Make sure the thread matches the hair on your wig closely so you won’t be able to see the stitching. A curved needle is best when you’re doing a lace-front wig sew in because the tip of the needle will be curved away from your scalp, making you less likely to poke yourself.
To secure the end of the braids, either pull them all into a ponytail or sew them down. To sew them, loop the tail up so it runs parallel to the rest of the braid. Then, run 2-3 stitches through the end of the braid and the body of the braid beside it. Tie a knot and cut off the excess string when you’re done. [3] X Research source If the braids are big or chunky, your wig won’t lay down flat. However, try not to braid too tightly, as this could lead to discomfort or even hair loss. [4] X Research source Cornrows often go from the front of your head to the back. However, for for a more protective style, you can part your hair down the middle and braid from the center down the sides of your head. For instance, the first braid might go down your temple, behind your ear, and to the nape of your neck.
For instance, if your hairline measures 12 in (30 cm) long, you’d cut your lace frontal to be 11 in (28 cm) long. A frontal is a hairpiece that covers the area from your hairline to the top of your head, from one ear to the other. Typically, you wear these with sew-in extensions. If you have a full lace-front wig, you shouldn’t have to cut it.
If you do wear a cap, you can sew it down with a few stitches near your temples, crown, and the base of your neck, if you’d like. Make sure to pass the needle through one of your braids to secure the cap. If you’re wearing a frontal, either skip the cap or choose a wide mesh so you’ll still be able to install your extensions.
Typically, it looks best if you line up the hairline of the wig with your natural hairline, but you can experiment with pulling it a little higher or lower to see what you like. It’s important to line up the hairline of the wig where you want it since it will be hard to adjust the wig once it’s sewed down.
If you’re wearing a stocking cap, sew through the material of the cap. Whether your braids run from front-to-back or from your center part down, you should have a braid that goes behind each ear. Make the stitches along this braid. All you need is a basic in-and-out stitch for this. However, if you’d like, you create an even more secure blanket stitch by passing the needle through the loop made by each stitch before you pull it tight.
Since you won’t normally part your hair along this line, these stitches won’t be visible. If you’re wearing a lace frontal, make these stitches along the back of the hairpiece. Hold the wig tightly to be sure it doesn’t slide back as you’re doing this.
Use the same simple stitch or blanket stitch you used on the opposite side.
If you’d like, you can make a row of front-to-back on either side of the wig.
Use the same basic stitch you used to hold the frontal in place. This will give you a thick head of hair that often looks more natural than using a full wig.
Be careful not to cut into the actual wig as you do this. Only cut the excess lace along your forehead.
This will help prevent the lace from lifting away from your forehead as you wear the wig. Got2b is a popular brand of glue gel for laying down the front of a wig, but you can use a different product, if you prefer.
Edge control is a fast-drying styling product that you can use to lay down the fine hairs near your hairline. Many high-quality wigs will feature these baby hairs. [16] X Research source You can use a sew-in lace front wig for a couple of months. It is better not to have it for longer than six to eight weeks. You can keep it for ten weeks at the maximum. After that, remove it, comb through and condition your hair and then put it back up.
